Fang Workholding Clamps

 NEW FANG STOPS 

The Fang Clamp is a stainless steel side-bite hold-down built for jobs where a vacuum isn’t an option. It drives teeth into the edge of your material, locking parts from the side and keeping them put even when the bottom side is uneven or rough. Use them on CNC router spoilboards or fixture plates with 1/4-20 or M6 screws for quick setups.

• Made of Stainless steel in America
• Side-bite hold down for uneven or "rough" material
  
• Screw to spoilboards or fixture plates
• Use wood screws or threaded like 1/4-20 or M6
• Compact design keeps clamp footprint minimal
• Ideal for slab flattening and tricky OP1 workholding
• Works on T-tracks, fixture plates, and spoilboards
• Size: 30mm wide x 78mm long
• Includes Gridfinity Storage Bin

Hardware Kit Includes

Each set of 4 includes a hardware kit. Thus, 16 Fang Clamps would have 4 Hardware Kits.

• 6ct - #10 x "Small" Square #2 wood screws
• 6ct - #10 x "Medium" Square #2 wood screws
• 6ct - Neoprene / Steel washers
• 6ct - Roller Washers - for spacing under/on top of a Fang clamp.
• 2ct - Stop Wedges - used for the "stop side."

The included Hardware Kit makes setups easier and faster and also helps to prevent excessive screw force from bending the clamps.

NEW – Fang Stops

Fang Stops are designed to be a sturdier, bigger sibling to Fang Clamps. Use these as the "fixed" setup side. If selected under Kit above, we will include two (2) Fang Stops per four (4) Fang Clamps.

Fang Stop option includes:
For every 4ct Fang Clamps

• Fang Stop - Stainless steel Teeth- 2ct
• Fang Stop - Plastic Base - 2ct
• #10 Square #2 screws, 1.25" long - 6ct
• Neoprene / Steel Washers - 6ct

Tip: You can use a screw or "stop" against the dimple at the back end of the clamp to make a more repeatable and steadfast hold.